Laboratory Investigation Of Mechanisms Governing Low Salinity Waterflooding In Oil Wet Carbonate Reservoirs

Improved oil recovery via wettability alteration by tuning the ionic composition of the injection water has been thoroughly researched in recent years. It has been well documented that seawater can increase the water wetness of chalk at high temperature. Forced displacement and spontaneous imbibition experiments have attributed the wettability alteration to interactions between active ions in the brine, Ca2+, Mg2+, and SO42-, the rock surface, and the oil phase. It has been suggested that the adsorption of SO42- onto the rock surface causes the bond between adsorbed carboxylic material in the crude oil and the rock surface to deteriorate which causes the release of the crude oil. Reduction in ionic strength of the injection water has also been proposed to trigger the effect of wettability alteration in carbonates. Although the numerous experiments devoted to understanding the mechanisms governing the low salinity effect in the past two decades, there has been no consensus about the dominant mechanisms driving wettability alteration. The purpose of this research is to improve the understanding of how reduced ionic strength and potentially determining ions (PDIs) contribute to oil recovery, as well as provide a direct comparison of their oil recovery performance for a synthetic oil versus crude oil during waterflooding. For this, a series of waterflood experiments were conducted in the laboratory at 90 C in Indiana limestone core plugs. Chemically tuned brines derived from seawater were used in secondary and tertiary recovery modes to displace synthetic oil. A waterflood with formation brine was also conducted as an experimental baseline to assess the advantages of low-salinity waterflooding over typical secondary recovery methods. Effluent analysis was conducted to evaluate the surface interactions occurring between the brine and rock surface. Gas chromatography-mass spectroscopy was performed to compare the chemical make-up of the synthetic and crude oil. Oil recovery curves from this study indicate that there was no benefit afterincreasing the concentration of PDIs in injection water compared to seawater (SW). However, the use of seawater and all chemically tuned brines derived from seawater resulted in an average 6.47% increase in oil recovery post water breakthrough, relative to the formation brine waterflood. The success of wettability alteration leading to improved oil recovery in carbonates has been noted as a strong function of the oil composition.